INSTRUCTION MANUAL EW
1-TO PROGRAM AND CHANGE THE USER CODE
a- First, open the door of your safe, without tuming rotary knob before you start to program your sale. Remove the battery compartment cover on the back of the door and place the batteries (4x1.5 batteries type AA) into the battery holder correctly. (Batteries included inside the safe).
b-Press the red button behind the door while the door is open, the yellow light wil be on with a short beep, please input the user code from 3-8 digits using any number from "0" to "9" within 30 seconds, then press "E" to confirm it
- To change the user code, please operate it as same procedures as above.
2-TO OPEN THE SAFE
Input the user code you programmed, then press "E", the green light will be on, please turn the knob within 5 seconds and pull out to open the safe. If wrong digit is input, you can press "C" to cancel it.
Note: Each press the yellow light will flash with a short beep, indicating that micro processor confirmed it. If the yellow light keeps on flashing with the beep means the code is wrong. Three times' wrong code will result the micro processor refuse to accept the input for 20 seconds, if press three times' wrong code again will result the micro processor refuse to accept for 5 minutes.
3-TO CLOSE THE SAFE
Close the door and tum the knob anti-clockwise will lock the safe.
1-TO PROGRAM AND CHANGE THE USER CODE
a- First, open the door of your safe, without tuming rotary knob before you start to program your sale. Remove the battery compartment cover on the back of the door and place the batteries (4x1.5 batteries type AA) into the battery holder correctly. (Batteries included inside the safe).
b-Press the red button behind the door while the door is open, the yellow light wil be on with a short beep, please input the user code from 3-8 digits using any number from "0" to "9" within 30 seconds, then press "E" to confirm it
- To change the user code, please operate it as same procedures as above.
2-TO OPEN THE SAFE
Input the user code you programmed, then press "E", the green light will be on, please turn the knob within 5 seconds and pull out to open the safe. If wrong digit is input, you can press "C" to cancel it.
Note: Each press the yellow light will flash with a short beep, indicating that micro processor confirmed it. If the yellow light keeps on flashing with the beep means the code is wrong. Three times' wrong code will result the micro processor refuse to accept the input for 20 seconds, if press three times' wrong code again will result the micro processor refuse to accept for 5 minutes.
3-TO CLOSE THE SAFE
Close the door and tum the knob anti-clockwise will lock the safe.
الحالة:
Neuf
الفئات:
أثاث
وضع في:
30-08-2025 à 18:52:20
